After a data error is discovered, you will not be able to input or edit data. In order to return memory to
normal (allowing further input and editing of data), you must perform the RESET operation to clear the
memory of all data. Before doing so, you may want to recall important data and write it down (if you don't
already have a copy). You can then re-input the data after clearing the memory.
The RESET procedure you should use depends on the type of message error message on the display.
"ARE YOU USING A NEW UNIT FOR THE FIRST TIME ?"
1. Make sure that NO is highlighted and then press set. If YES is highlighted, press
highlighting to NO and then press SET.
The message "DATA ERROR ! CHECK YOUR USER'S GUIDE FOR PROCEDURE !" appears on the
display at this time.After this message appears, you can press CLEAR to clear it from the display and
recall data in order to make a back-up record of it before continuing.
2. Press the RESET button, which is located inside the battery compartment cover on the back of the unit.
This causes the "CLEAR MEMORY AND SET UP THE UNIT FOR OPERATION ?" message to
appear on the display.
to move the highlighting to YES and then press SET to reset the uint.
Highlighting NO and pressing SET clears the reset message and displays the Home Time screen.
"CLEAR MEMORY AND SET UP THE UNIT FOR OPERATION ?"
1. Make sure that YES is highlighted. If OFF is highlighted, press
Highlighting OFF and pressing SET turns off the unit without resetting the unit.
2. Press SET to reset the unit.
If you still have trouble after trying the RESET operation, you may have a hardware problem.
lf a low battery power message appears on the display or if the display remains blank when you
turn power on, replace batteries as soon as possible.
2. press OFF to switch power off.
About Auto Power Off function...
The SF Unit is equipped with an Auto Power Off function that switches power off automatically when-
ever you do not perform any key operation for about six minutes. To restore power, press ON.
To turn on the EL backlight
There are two ways to turn on the backlight of the display.
Pressing LIGHT causes the backlight to turn on for about 15 seconds, and then turn off automatically.
Pressing SHIFT and then LIGHT also turns on the backlight, but in this case the backlight stays on as
long as you keep performing key operations on the SF Unit .
The backlight turns off automatically if you do not perform any key operation for about 15 seconds.
Leaving the backlight on for long periods greatly reduces battery life!
You can manually turn the backlight off by pressing LIGHT again.
Failure of the backlight to turn on indicates low battery power. Replace batteries as soon as possible.
to move the highlighting to YES.
— 6 —
to move the