Remote Control Features - NEC MultiSync VT440 User Manual

Remote Control Features

1 Source Button
Press to select a video source.
2 Auto Adjust Button
Use this button to adjust Position-H/V and Pixel Clock/Phase for
an optimal picture. Some signals may not be displayed correctly,
or in some cases it may take some time for a source to switch be-
tween sources.
3 Menu Button
Displays the menu.
4 Select ( ) / Volume (+) (–) Buttons
: Use these buttons to select the menu of the item you wish
to adjust.
: Use these buttons to change the level of a selected menu
item.
A press of the button executes the selection. When no menus
appear, these buttons work as a volume control.
When the pointer is displayed, these
pointer.
5 Enter Button
Use this button to enter your menu selection.
6 Cancel Button
Press this button to exit "Menus". Press this button to return the
adjustments to the last condition while you are in the adjustment
or setting menu.
7 Magnify Button
Use the (+) or (–) button to adjust the image size up to 400%.
When the Pointer is displayed, the magnified image is displayed at
the center of the Pointer. When the Pointer is not displayed, the
magnified image is displayed at the center of the screen.
When the image is magnified, the pointer is changed to the magni-
fying icon.
8 Pointer Button
Press this button to display one of the eight pointers; press again to
hide the pointer. You can move your pointer icon to the area you
want on the screen using the Select button.
9 Picture Mute Button
This button turns off the image and sound for a short period of
time. Press again to restore the image and sound.
10 Help Button
Provides information about operation and adjustment procedures
or the set information for the current menu or adjustment during
menu operation. This also displays information how to use the Help.
11 Power Button
If power is applied, you can use this button to turn your projector
on and off.
NOTE: To turn off the projector, press and hold the POWER but-
ton for a minimum of two seconds.
Remote Control
buttons move the
NOTE: Remove the transparent insulation tape before use. See
page E-34 for battery installation.
12 Infrared Transmitter
Direct the remote control toward the remote sensor on the projec-
tor cabinet.
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Do not place the battery upside down.
NOTE: Before you use the card remote control for the first time, be
sure to remove the insulation tape from the card remote control.
* Keep the coin cell battery out of reach of children so as not to
allow them to swallow the cell battery.
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by
the manufacturer.
Dispose of used batteries according to your local regulations.
E–12
1
SOURCE
3
Vol.+
SELECT
Vol.–
5
POINTER
MAGNIFY
7
HELP
RD-366E
10
12
AUTO
2
ADJ.
4
6
8
PIC.
MUTE
9
POWER
11