Operation; Connecting The Power Cable And Turning On The Projector - NEC LT157 User Manual

3. OPERATION

Connecting the Power Cable and Turning on the
Projector
Before you turn on your projector, ensure that the computer or video
source is turned on and that your lens cap is removed.
1. Connect the supplied power cable to the projector.
Plug the supplied power cable in the wall outlet. The projector will
go into its standby mode and the power indicator will glow orange.
2. Turn on and off the Projector
OFF
POWER
VIDEO S-VIDEO RGB1
AUTO ADJ.
P C
C O
N T
R O
L V I D
E O
S - V
I D E
O
To turn on the projector:
Only after you press the "On" button on the remote control ("ON/
STAND BY" button on the projector cabinet) will the power indicator
turn to green and the projector become ready to use.
NOTE: To turn the projector on by plugging in the power cable, use the
menu and enable the "Auto Start" feature. (See page E-38.)
NOTE: Immediately after turning on the projector, screen flicker may occur.
This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
D I O
A U
B
R G
O
I D E
S - V
E O
V I D
L
R O
N T
C O
D P C
A R
C C
B
U S
I N
A C
ON
Power ON button
RGB2
LASER
Indicator
Power ON/STAND BY button
To turn off the projector:
First press the "off" button on the remote control ("ON/STAND BY"
button on the projector cabinet) for a minimum of two seconds. The
power indicator will glow orange. After the projector turns off, the
cooling fans keep operating for one minute.
NOTE: Do not disconnect the power cable during this time. Then, unplug
the power cable. The power indicator will go out.
Status of indicator light: turn on
Normal mode:
stand by
STATUS
POWER
steady orange light
Eco mode:
stand by
STATUS
POWER
steady orange light
Status of indicator light: turn off
ON
POWER
steady green light
E – 24
ON/
STAND BY
STATUS STATUS
POWER POWER
flashing green light steady green light
for one minute
ON/
STAND BY
STATUS STATUS
POWER
POWER
flashing green light steady green light
for one minute (Eco mode)
(Normal mode)
Press a minimum
ON/
of two seconds.
STAND BY
cooling down stand by
POWER POWER
change to flashing steady orange light
green light