Toyota 2016 Landcruiser Manual page 465

■
How to initialize the tire pressure warning system
1
Park the vehicle in safe place and turn the engine switch to OFF.
Initialization cannot be performed while the vehicle is moved.
2
Adjust the tire inflation pressure to the specified cold tire inflation
pressure level. (P. 558)
Make sure to adjust the tire pressure to the specified cold tire infla-
tion pressure level. The tire pressure warning system will operate
based on this pressure level.
3
Turn the engine switch to IGNITION ON mode.
4
Press and hold the tire pres-
sure warning reset switch
until the tire pressure warn-
ing light blinks slowly 3 times.
"--" will be displayed for inflation pressure of each tire on the multi-
information display while the tire pressure warning system deter-
mines the position on the multi-information display.
When position of each tire is determined, the inflation pressure of
each tire will be displayed on the multi-information display.
5
Drive the vehicle at approximately 25mph (40 km/h) or more for
approximately 10 minutes.
When initialization is complete, the inflation pressure of each tire will
be displayed on the multi-information display.
Initialization will take longer than approximately 10 minutes if the
vehicle is stopped for a long time, such as at traffic signals.
◆
Registering ID codes
The tire pressure warning valve and transmitter is equipped with a
unique ID code. When replacing a tire pressure warning valve and
transmitter, it is necessary to register the ID code. Have the ID code
registered by your Toyota dealer.
LC200_OM_OM60M88U_(U)
6-3. Do-it-yourself maintenance
I n f o r ma t i o n P r o v i d e d b y :
465
6