Location Of Keys; Basic Operation; Faceplate Release; Sound Adjustment - VIETA VC-HU720BT User Manual

Operation

Location of Keys

1. Volume Buttons s t
(SEL/MUNE)
2. AUX IN
3. (release button)
BND
5. LCD
6. 5/DIR-
7. 4/RDM
8. 1/PAU
9. 2/INT
10. MODE
11. 3/RPT
12.

/MUTE

22
13. 6/DIR+
14. USB interface
15. PTY/AF
16. Reset button
17. Memory Card interface
18. DISP
19. AMS
20. MON
21. EQ/TA
22. / (tune/seek/track down/up buttons)
23.1-6 preset buttons
USB/SD Radio

Basic Operation

SWITCHING ON/OFF THE UNIT
Press button to turn on the unit, When the unit is
on, press and hold button to turn the unit off.

FACEPLATE RELEASE

Press button to detach the removable faceplate.

SOUND ADJUSTMENT

Shortly press Volume knob button to enter AUDIO
SETTING mode, use Volume knob button to select
the desired adjustment mode. The adjustment mode
will change in the following order:
BAS, TRE, BAL, FAD
Use the volume knob to the left or right to Adjust the
volume

SYSTEM SETTING

Press and hold the volume button (1) on the front
panel to enter system setting mode. Then briefly
press the volume button (1) to select the item you
want to change and rotate the volume knob (1) to
change the corresponding setting.
1) BEEP ON/OFF
Use to set Beep sound on or off.
2) P-VOL
Use Volume Up/Down button to select the volume
level when the unit turns on.
3) AREA EUR/USA
Use Volume Up/Down button to set EUR or USA area
frequency spacing.
MUTE
Shortly press MUTE button will mute the sound
instantly, press it again will resume the sound.
LOUDNESS
Press LOU button for several seconds to switch
loudness function on, and "LOUD" will appear on the
LCD.
Press it for several seconds again to release this
function, and "LOUD" will disappear.

SET THE CLOCK

Press the DISP button shortly until the clock is shown
on the LCD display. Then hold down DISP button
until the clock flashes. Then rotation the volume
button to change minutes or to change hours.
DISPLAY INFORMATION
Press DISP button (18) to operate as the conversion
of each display mode.
EQUALIZATION
Press EQ/TA button to turn on equalization function
and to select desired audio mode. There are several
kinds of mode as below:
FLAT, CLASSIC, POP, ROCK, EQ OFF

RESET FUNCTION

RESET button must be activated with either a
ballpoint pen or thin metal object. The RESET button
is to be activated for the following reasons:
- Initial installation of the unit when all wiring is
completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button, the unit can't work yet,
please use a cotton swab soaked in isopropyl alcohol
to clean the socket on the front panel.

MODE SELECTION

Shortly press MODE button to select the desired
mode, such as Radio, USB, CARD, AUX mode.
When there isn't an USB or CARD connected to the
unit, the corresponding mode will be skipped.

AUXILIARY INPUT

The unit can be connected to a portable audio
player through the AUX IN jack on the front panel.
After finishing the connection, you can press MODE
button on the front panel to switch the mode to AUX
IN mode.
23
ENGLISH