Axis Q1615-E Installation Manual page 20

Note
• The weight of the camera is 3525 g (7.7 lb). Check that the material is strong enough to
support this weight.
• Using any other than the provided cable gland may cause water to seep in and damage
the product.
• Always use a shielded network cable (STP) intended for outdoor use between the
Axis product and the end point and ensure that the end point is properly grounded.
Installations of Axis products using a shielded network cable (STP) and a properly
grounded end point have been tested to comply with industry immunity standard levels
such as surge protection. Any other installation method will void the warranty and
leave the unit at a risk.
• An optional cable with a diameter of 4.0 mm - 5.5 mm should be routed through a
separate cable gland. See Hardware Overview, on page 10.
1. Use the supplied drill template to prepare a wall or pole for installation of the wall
bracket.
2. Route the network cable through the wall bracket, and through the bracket adapter.
Leave approximately 30 cm (11.8") of cable for connecting to the camera.
3. Install the wall bracket on a wall, ceiling, or pole using screws and plugs appropriate for
the material (e.g. wood, metal, sheet rock, stone).
Do the following to route the network and other (optional) cables:
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
2. Remove the cap, the plug and the gasket from the cable gland to be used.
3. Route the network cable through the cap.
4. Slide the network cable through the slit in the gasket.
5. Route the network cable through the cable gland.
6. Press the gasket into the cable gland and screw the cap on firmly.
Do the following to attach the camera to the wall bracket
1. Place the camera with the bottom cover on the wall bracket and tighten the bracket
screws.
2. Replace the cable cover and tighten the screws.
3. Connect the cables. See Connect the Cables, on page 21.
4. Loosen the bracket adjustment screw to focus the camera; focus the camera according
to the instructions under Adjust Focus, on page 21.
5. Also see Access the Product, on page 21 to access the video stream.
6. Attach the safety wire in the top cover to the tab in the bottom cover. See image under
Hardware Overview, on page 10.
AXIS Q1615-E Network Camera
20