Axis Q1615-E Installation Manual page 13

AXIS Q1615-E Network Camera
Power Green
Amber
Note
• The Status LED can be configured to be unlit during normal operation. To configure, go
to Setup > System Options > Ports & Devices > LED. See the online help for more
information.
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System
Options > Maintenance .
• The Power LED can be configured to be unlit during normal operation. To configure, go
to Setup > System Options > Ports & Devices > LED. See the online help for more
information.
• The Network LED can be disabled so that it does not flash when there is network traffic.
To configure, go to Setup > System Options > Ports & Devices > LED. See the online
help for more information.
LED
Color
Housing Green
(fan and
Flashing
heater)
green
Note
This status LED referred to in the table above is located in the housing.
Normal operation.
Flashes green/amber during firmware upgrade.
Indication
Normal operation.
Single flash: Heater error
Double flash: Fan error
Triple flash: General error
Alarm events will be triggered through the camera's input port.
Contact your Axis reseller for information about spare parts and
troubleshooting.
13