Table of Contents
Advertisement
Connect the mains plug to the mains socket only at the end of
•
the installation process. Make sure that the mains plug is
accessible after installation..
The ventilation opening in the base (if applicable) must not be
•
covered by a carpet, mat, or any floor covering.
Ensure good air ventilation in the located room to avoid the
•
back flow of gases into the room from appliances burning gas
or other fuels, including open fires.
Exhaust air must not be discharged into a flue which is used for
•
exhausting fumes from any appliances burning gas or other
fuels.
The operating water pressure at the water entry point from the
•
outlet connection must be between 0.5 bar (0.05 MPa) and 8
bar (0.8 MPa).
Do not exceed the maximum load of 7 kg (refer to the
•
"Programme chart" chapter).
The appliance must be connected to the water mains using the
•
new supplied hose sets, or other new hose sets supplied by
the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
Wipe away lint or packaging debris that has accumulated
•
around the appliance.
Items that have been soiled with substances such as vegetable
•
or mineral oil, acetone, alcohol, petrol, kerosene, spot removers,
turpentine, waxes and wax removers should be washed
separately with an extra amount of detergent before being dried
in the washer dryer.
Do not use the appliance if items have been soiled with
•
industrial chemicals.
Do not dry unwashed items in the wash dryer.
•
Items such as foam rubber (latex foam), shower caps,
•
waterproof textiles, and rubber backed articles and clothes, or
pillows fitted with foam rubber pads should not be dried in the
washer dryer.
3
Hide quick links:
Advertisement
Table of Contents
