Daily Use - Washing & Drying - Zanussi ZWD 71460 NW User Manual

calculates also the duration of the anti-
crease and the cooling phases.
2. Press to start the programme.
• The display shows regularly a new time
value.
• The drying indicator
• The display shows the door locked
indicator
If you set only 10 minutes of drying,
the appliance performs only a cooling
phase.
If the laundry is not sufficient dry, set
again a short drying time.
END OF THE DRYING PROGRAMME
The appliance stops automatically.
• The acoustic signals operate (if they are active).
DAILY USE - WASHING & DRYING
WARNING! Refer to Safety chapters.
NON-STOP PROGRAMME
1. Turn the programme knob to
appliance.
2. Load the laundry one item at a time.
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.
3. Put the detergent and the additives in the
appropriate compartment.
4. Turn the programme dial to the washing
programme.
The display shows the indicators of the different
washing phases.
5. Set the available options.
WASHING & AUTOMATIC DRYING
1. Press again and again until the display
shows one of the dryness level indicator:
• : IRON DRY level indicator for cotton
items
• : CUPBOARD DRY level indicator for
cotton and synthetic items
starts to flash.
.
to activate the
• In the display comes on.
• The indicator
• The last minutes of the drying cycle the
appliance performs a cooling and anti-crease
phase. The door is still locked.
When the door locked
you can open the door.
1. Turn the programme knob to
the appliance.
After some minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
2. Remove the laundry from the appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew and
odours.
4. Close the water tap.
• : EXTRA DRY level indicator for cotton
items
The display shows the indicator
on the display is the duration of the washing +
drying cycles, calculated on a default load size.
To have a good drying the appliance
does not let you set a too low spin
speed for the items to be washed and
dried.
2. Press to start the programme.
In the display the indicator of the set dryness level
stays on.
The door locked indicator
The display shows regularly a new time value.
The last minutes of the drying cycle
the appliance performs the anti-crease
and the cooling phases.
WASHING & TIMED DRYING
To have a good drying the appliance does not let
you set a too low spin speed for the items to be
washed and dried.
1. Press to set the drying time value. The
display shows 10 minutes.
The indicator comes on in the display. The
display shows the set drying value time. for
example: . After some seconds the display
goes off.
goes off in the display,
to deactivate
. The time value
goes on.
17