Installation - IKEA RAFFINERAD Manual

ENGLISH
Technical data
The technical informations are situated in the
rating plate inside the appliance.

Installation

After unpacking the oven, make sure that
it has not been damaged during transport
and that the oven door closes properly. In
the event of problems, contact the dealer or
your nearest Authorized Service Centre. To
prevent any damage, only remove the oven
from its polystyrene foam base at the time of
installation.
Preparing the housing unit
• Kitchen units in contact with the oven must
be heat resistant (min 90°C).
• Carry out all cabinet cutting work before
fitting the oven in the housing and remove
all wood chips and sawdust.
• After installation, the bottom of the oven
must no longer be accessible.
• For correct appliance operation, do not
obstruct the minimum gap between the
worktop and the upper edge of the oven.
General recommendations
Before use
- Remove cardboard protection pieces,
protective film and adhesive labels from
accessories.
- Do not remove the rating plate situated on
the right side of the door frame.
- Remove the accessories from the oven
and heat it at 200° for about an hour to
eliminate the smell and fumes from the
insulating materials and protective grease.
During use
- Do not place heavy objects on the door as
they could damage it.
- Do not cling to the door or hang anything
from the handle.
- Do not cover the inside of the oven with
aluminium foil.
- Never pour water into the inside of a
hot oven; this could damage the enamel
coating.
- Never drag pots or pans across the
bottom of the oven as this could damage
the enamel coating.
- Make sure that the electrical cables of
other appliances do not touch hot parts of
the oven or become trapped in the door.
- Do not expose the oven to atmospheric
agents.
28