Reference Section; Troubleshooting - Haier LE32A650CF Instruction Manual

Reference Section

Reference Section

Troubleshooting

Symptoms
No power
No picture
Good picture but no sound
Good sound but poor colour
Poor picture
Snowy picture and noise
TV not responding to remote
control
TV not working
No file displayed in USB
mode
Note Note
• If the problem is not solved by following these troubleshooting instructions, consult your local authorised service
centre.
• The TV set must only be repaired by qualified, registered service personnel. Never attempt to remove the back cover, as
the TV set contains dangerous voltage that may cause injury or fire.
EN-24 LED Backlit Flat TV Instruction Manual
Items to Check and Actions to Follow
• Check if the TV's AC power cord is plugged into a working power outlet.
• Unplug the TV, and wait 60 seconds. Then reinsert plug into the working
power outlet and turn on the TV again.
• Make sure correct input source is selected.
• Check antenna connection on the back of the TV to see if it is properly
connected.
• Possible broadcast station trouble. Try another channel.
• Adjust the picture contrast and brightness settings.
• Increase the volume level by pressing VOL+ button on the remote control
or on TV side control panel.
• Press button on the remote control to ensure mute is off.
• Adjust the contrast, colour and brightness settings.
• Poor picture quality may occur when an activated S-VHS camera or
camcorder is connected to your TV and the other peripheral at the same
time. Switch off one of the peripherals.
• Check the antenna connection.
• Check whether the batteries are working. Replace if necessary.
• Make sure the remote control batteries are installed correctly.
• Clean the remote control sensor lens on the TV.
• You can still use the control buttons on the side of your TV.
• Disconnect the TV from the power supply for 10 seconds, then reconnect
the TV. If the problem persists, contact authorised service personnel for
technical assistance.
• Make sure you select correct media type.
• Make sure the stored files are in supported format.