Setting Up Indoor Unit Pcb And Wired Remote Controller Option Switches - Samsung MWR-TH00 Installation Manual

Setting up indoor unit PCB and Wired
Remote Controller Option switches
Indoor unit PCB
If you control the indoor unit with the wired remote
controller, adjust K1 of SW4 option switch of the
indoor unit PCB to 'OFF'.
If you install the indoor unit as shown in the picture,
can control it with the wired remote controller.
ADDRESS of the wired remote controller and RMC
ADDRESS of the indoor unit should be assigned as
the same.
Therefore as the RMC ADDRESS is adjusted to
'0' in the picture, the indoor unit is controlled by
the wired remote controller which is adjusted to '0'.
Wired remote controller PCB
Assign the RMC ADDRESS of the wired remote
controller same as the indoor unit to be controlled.
RMC
SW4
Indoor unit MAIN PCB switch
DS03
ADDRESS Switch
9
E-