Wired Remote Controller and Accessories
Accessories
The following accessories are supplied with the air conditioner.
The number of each accessory is indicated in parentheses.
Cable-tie (2) Cable clamp (5) M4x16 tapped
4
E-
Indoor Unit
screw (7)
Power Drawing
Cable (1)
1
Adjust K1 DIP switch(SW03) on the PCB to the "OFF"
position.
C C
A A
U U
T T
I I
O O
N N
C C
A A
U U
T T
I I
O O
N N
The wired remote controller must be installed by an
installation specialist.
Before installing the wired remote controller, check
that you have turned off the main power.
All cables should be installed according to the
national wiring rules and you must install it to the
wall not to be touched by users.
Communication cable and power cable should be
installed separately.
(Connecting the power cable to communication
terminal will cause serious damage to the wired
remote controller. Please make sure that the power
cable is connected to the appropriate power terminal
to avoid serious damage.)
Communication
Wire joint (1)
cable of the wired
remote controller (1)
User's
manual (1)