Installation - Samsung MWR-TH00 Installation Manual

Installing to COM1(F1, F2) (cont.)
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
DS01 DS02
8
E-

Installation

1 Open the wired remote controller by using 2 grooves on its
top.
2 Secure the rear cover of the wired remote controller on the
wall with 2 screws.
3 Connect each F1, F2, V1, V2, indoor unit terminal with
the wired remote controller terminal F1, F2, V1, V2.
When connecting the communication cable and
the power cable, don't confuse about each cable.
If the cables are connected improperly, the wired
remote controller will not work.
4 After checking the kind of outdoor unit, assign the DS01
switch SW2 of the indoor unit PCB to ON.
If you set to COM2 and install it to COM1, '606' of
error signs is displayed on the wired remote
controller.
Switch
Switch OFF
No.
SW1
Cooling Only
SW2
COM2(F3, F4)
SW3 °C
The wired and
wireless remote
SW4
controller available
Refer to the chapter 'Additional Function of the wired
SW5
remote controller'.
5
Reassemble the wired remote controller.
Switch ON
Cooling and Heating
COM1(F1, F2)
°F
Can be used
wired remote controller
only