Samsung MWR-TH00 Installation Manual page 30

Additional Function of the Wired Remote Controller (cont.)
30
E-
Initial display
is displayed if the group has never been set.
If the group is set, the LCD receives the current indoor
unit ADDRESS(main address) and group ADDRESS
(RMC) from the indoor unit and displays them.
Changing of group ADDRESS (RMC)
Press the button to select the required group
ADDRESS. Then, the group ADDRESS display flickers
and changes.
Setting the group ADDRESS
Press the button once to set the selected group
ADDRESS with the 'beep' sound.
Quit
Press the button again to quit the setting mode and
enter the operation mode.
If you press the
'Canceling the group ADDRESS', quit the 'Setting the
RMC switch group ADDRESS mode'.
C C A A U U T T I I O O N N
C C A A U U T T I I O O N N
When assigning the RMC, the wired remote
controller of each indoor unit should be installed
one to one.
If you assign the RMC to the indoor unit with the
wired remote controller, the indoor unit is
controlled by the RMC(assigned with the wired
remote controller) in the centralized controller
even if the RMC is set to the indoor unit PCB
manually.
button in the mode except the