Installation - Danfoss TS715 Installation & User's Instructions

Installation

J
Remove wallplate from unit by unscrewing the two
screws on the bottom edge of the unit.
J From the top left hand corner of the wallplate, there
must be clearances of at least 140 mm to the right,
15mm to the left, 30mm above and 100mm below in
order to mount the plug-on module.
J The wallplate must be securely mounted either
directly to the wall using suitable wood screws or to a
fl ush mounted 1-gang electrical accessory box using
M3.5 screws.
J Cable access can either be from behind for
concealed cabling, or from below for surface cabling.
If surface cable is used, cut out cable access slot on
plug-on module prior to mounting the module.
J For wiring connections refer to diagram on page 5.
TS715 models are double insulated and do not
require an earth connection, however a parking
terminal is provided on the wallplate. This is clearly
marked with an Earth symbol.
J Prior to mounting the plug-on module, DIL switches
on the rear of the plug-on module must be set. See
diagram on page 5 for available options.
J Mount plug-on module to wallplate by locating tabs
on top of wallplate in apertures on rear of module,
hinge down and press fi rmly to wallplate before
tightening securing screws on bottom of wallplate.
4