Installation; Installing The Drive - Sony MPF920-Z User Manual

Installation

Installing the
Drive
Caution
Before installing the drive, turn off your
computer and unplug it from the AC
power outlet. Failure to do so may result
in electric shock.
To Install the Drive
1
Unplug your computer from the
AC power outlet.
2
Remove the cover from your
computer.
For details about this procedure,
refer to your computer
documentation.
3
Locate the following cables:
• Floppy disk interface cable: flat,
"ribbon" type cable with 34-pin
female connector.
• Power cable: two or four separate
wires attached to a single 4-pin
female connector.
4
Install the drive into an available
drive bay.
5
Connect the floppy disk interface
cable to the FDD interface
connector at the rear of the drive,
as illustrated.
6
5
1 FDD interface connector
2 Connector A
3 Floppy disk drive interface cable
4 Connector B
5 Pin #1 indicator stripe (usually
red or blue)
6 Pin #1
Notes
• Make sure that the pin #1 indicator
strip of the floppy disk interface
cable (usually red or blue) is
aligned with pin #1 of the 34-pin
female connector at the rear of the
drive.
• To assign the drive as your
computer's A: drive, connect
connector A to the FDD interface
connector. To assign the drive as
your computer's B: drive, connect
connector B to the FDD interface
connector. Make the appropriate
changes to the CMOS BIOS.
1
2
3
4
GB
11