Kubota M8540 Operator's Manual page 33

4. Place the PTO clutch control lever in
"OFF" position and hydraulic control
levers in "LOWEST" position.
(1) PTO clutch control lever
(2) Position control lever
(3) Draft control lever
5. Set the throttle lever to about 1/2 way.
(1) Hand throttle lever
(2) Foot throttle
"ON" "OFF"
(A) "DOWN"
"INCREASE"
"DECREASE"
OPERATING THE ENGINE
6. Insert the key into the key switch and
turn it "ON".
"OFF" "ON"
C Check Easy Checker(TM) Lamps:
1. When the key is turned "ON", lamps (2) (3) should
come on. If trouble should occur at any location while
the engine is running,
corresponding to that location comes on.
2. Suppose that the engine coolant temperature is not
high enough yet. The heater indicator (4) also comes
on when the key is turned "ON" to preheat the engine
and goes off automatically when preheat is completed.
Illumination time of indicator varies according to the
temperature of coolant
3. The PTO clutch indicator (1) comes on while PTO
clutch control lever is engaged "ON" and goes off
when disengaged "OFF" it.
(1) PTO clutch indicator
(2) Electrical charge indicator
(3) Engine oil pressure indicator
13
"START"
the indicator lamp
(4) Heater indicator
(5) Fuel level indicator
(6) Key switch