Kubota M8540 Operator's Manual page 15

5. USING 3-POINT HITCH
1. Use the 3-point hitch only with equipment designed for
3-point hitch usage.
2. When using a 3-point hitch mounted implement, be
sure to install the proper counterbalance weight on the
front of the tractor.
3. When transporting on the road, set the implement
lowering speed knob in the "LOCK" position to hold the
implement in the raised position.
(1) 3-point hitch lowering speed knob
6. SERVICING THE TRACTOR
Before servicing the tractor, park it on a firm, flat and level
surface, set the parking brake, lower all implements to the
ground, place the gear shift lever in neutral, stop the
engine and remove the key.
1. Allow the tractor time to cool off before working on or
near the engine, muffler, radiator, etc.
2. Do not remove radiator cap while coolant is hot. When
cool, slowly rotate cap to the first stop and allow
sufficient time for excess pressure to escape before
removing the cap completely. If the tractor has a
coolant recovery tank, add coolant or water to the tank,
not the radiator. (See "Checking Coolant Level" in
"DAILY CHECK" in "PERIODIC SERVICE" section.)
3. Always stop the engine before refueling. Avoid spills
and overfilling.
4. Do not smoke when working around battery or when
refueling. Keep all sparks and flames away from
battery and fuel tank. The battery presents an
explosive hazard, because it gives off hydrogen and
oxygen especially when recharging.
5. Before "jump starting" a dead battery, read and follow
all of the instructions. (See "JUMP STARTING" in
"OPERATING THE ENGINE" section.)
6. Keep first aid kit and fire extinguisher handy at all
times.
7. Disconnect the battery's ground cable before working
8. To avoid the possibility of battery explosion, do not use
9. To avoid sparks from an accidental short circuit,
(1) Battery
(A) "FAST"
(B) "SLOW"
10. Do not attempt to mount a tire on a rim. This should be
(C) "LOCK"
11. Always maintain the correct tire pressure. Do not
12. Securely support the tractor when either changing
13. Make sure that wheel bolts have been tightened to the
14. Do not work under any hydraulically supported
SAFE OPERATION
on or near electric components.
or charge the refillable type battery if the fluid level is
below the LOWER ( lower limit level ) mark. Check the
fluid level regularly and add distilled water as required
so that the fluid level is between the UPPER and
LOWER levels.
always disconnect the battery's ground cable (-) first
and reconnect it last.
done by a qualified person with the proper equipment.
inflate tires above the recommended pressure shown
in the operator's manual.
wheels or adjusting the wheel tread width.
specified torque.
devices. They can settle, suddenly leak down, or be
accidentally lowered. If it is necessary to work under
tractor or any machine elements for servicing or
adjustment, securely support them with stands or
suitable blocking beforehand.
5
-