Replacing Light Bulb; Replacing Head Lamp - Kubota M8540 Operator's Manual

88 PERIODIC SERVICE
FUSE CAPACITY
No. (A)
(1) 15 Work Light R
(2) 15 Work Light L
(3) 5 Alternator, Engine, Heater
(4) 5 Meter Panel, OPC
(5) 10 Turn Signal
(6) 15 Auxiliary Power
(7) 5 Meter (Back Up)
(8) 20 Head Light, Tail Lamp
(9) 15 Flasher (Hazard)
(10) 5 Starter Relay
(11) 40 Key Switch, Head Light, Hazard
(12) 30 Fuel Cut Solenoid
(13) 50 Charge, Air Heater
BReplacing Light Bulb
Light
Head light
Hazard light
Turn signal
Tail light
Work light (if equipped)
Front work light
Protected circuit
Capacity
12 V, 55 / 60 W (H4)
12 V, 23 W
12 V, 21 W
12 V, 5 W
12 V, 35 W
12 V, 21 W
BReplacing Head Lamp
To avoid personal injury:
A Be careful not to drop the bulb, hit anything
against the lamp, apply excess force, and get
the lamp scratched. If broken, glass may cause
injury. Pay more attention to halogen lamps in
particular, which have high pressure inside.
A Before replacing the lamp, be sure to turn off
the light and wait until the bulb cools down,
otherwise, you may get burned.
1. While pushing the right and left lock buttons, pull and
remove the electrical connector.
2. Remove the rubber boot.
3. Remove the clamping fixture and take out the bulb.
4. Replace with a new bulb and reinstall the head lamp
assembly in the reverse order.
(1) Electrical connector
(2) Lock buttons
(3) Rubber boot
(4) Clamping fixture
(5) Bulb
A Be sure to use a new bulb of the specified wattage.
A Never touch the bulb surface (glass) with bare hands.
Fingerprints, for example, may break the bulb.
(A)"Base's wider projection to face
upward"