Remove The Contact Metals; Replace The Plasma Panel - Panasonic TC-P60ZT60 Service Manual

9.2.27. Remove the Contact metals

1. Remove the screws (×10
2. Remove the Tape from the Contact metal side (L, R).
3. Remove the Contact metal side (L, R).
4. Remove the screws (×15
5. Remove the Tape from the Contact metal bottom.
6. Remove the Contact metal bottom.
9.2.28. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
2. Disconnect the flexible cable (C10).
3. Disconnect the connectors (C14 and C18).
4. Remove the screws (×5
9.2.29. Remove the C2-Board
1. Disconnect the flexible cables (CB6, CB7, CB8, CB9,
CB10 and CB11).
2. Disconnect the flexible cables (C20, C21 and C26).
3. Disconnect the connectors (C24 and C28).
4. Remove the screws (×6
).
).
) and remove the C1-Board.
) and remove the C2-Board.
9.2.30. Remove the C3-Board
1. Disconnect the flexible cables (CB12, CB13, CB14 and
CB15).
2. Disconnect the flexible cables (C31 and C36).
3. Remove the screws (×4

9.2.31. Replace the Plasma panel

Caution:
Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
A new Plasma panel itself without Contact metals is fragile.
To avoid the damage to new Plasma panel, carry a new
Plasma panel taking hold of the Contact metals.
1. Place a carton box packed a new Plasma panel on the
flat surface of the work bench.
2. Open a box and without taking a new Plasma panel.
3. Attach the Cabinet assy and each P.C.Board and so on,
to the new Plasma panel.
25
) and remove the C3-Board.