9.2.19. Remove the SS-Board
1. Disconnect the connector (SS11).
2. Disconnect the flexible cable (SS33).
3. Disconnect the flexible cables (SS62 and SS64).
4. Remove the screws (×5
Board.
9.2.20. Work instructions for the Rubber
sheet for SS-Board
1. Rubber sheets are put between the board and rear cover
for EMC requirement and heat radiation. Confirm rubber
sheets were placed at each portion when assembling as
shown in figure.
, ×3
) and remove the SS-
9.2.21. Remove the SS2-Board
1. Disconnect the flexible cable (SS65 and SS67).
2. Remove the screws (×2
9.2.22. Remove the USB cable (A-WiFi)
1. Remove the screw (×1
2. Remove the USB cable (A-WiFi).
9.2.23. Remove the Metal bracket bottom
1. Remove the screws (×6
bracket bottom.
23
) and remove the SS2-Board.
).
, ×2
) and the Metal