9.2.24. Remove the M8 nut metals
1. Remove the screws (×2
metals.
9.2.25. Remove the K-Board
1. Remove the screws (×2
case.
2. Disconnect the connector (K10).
3. Remove the claw (×1
4. Remove the LED panel.
each) and remove the M8 nut
) and remove the LED panel
) and remove the K-Board.
9.2.26. Remove the Cabinet assy from the
Plasma panel section
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the screws (×21
3. Remove the Cabinet assy from the Plasma panel section.
24
).