Filtered Water Faucet - Winnebago Tour 2012 Operator's Manual

SECTION 7 –
PLUMBING
2. Turn water pump switch to "OFF" position.
3. Fill water tank.
4. Open all faucets, hot and cold.
5. Turn on water pump switch.
6. Close each faucet as it begins to deliver a
steady stream of water (close cold water first).
Leave hot water faucets on until they also
deliver a steady stream of water. This will
ensure that the water heater is filled with
water.
7. Check to be sure pump stops soon after all
faucets have been closed.
8. Pump is now ready for automatic operation.
Pump will start when a faucet is opened and
stop when the faucet is closed.
Water Pump
(Located in passenger compartment
near front of coach)
-Typical View
Water Pump Switch
(Located on monitor panel)
-Typical View
7-4
Water Pump Switch
(Located in water service center)
-Typical View
Water Pump Switch
(Located in bath area)
-Typical View

FILTERED WATER FAUCET

–If Equipped
The filtered water faucet is connected to a
flow-through, activated carbon filter cartridge
that removes chlorine and odors for taste-free
drinking water.