Leckey Tour Mobility Base User Instructions page 7

8.2 Handle bar height
The handle bar can be adjusted to a height
that is suitable for the person pushing the
seat. In order to adjust the height of the
handle bar, please refer to Fig 6.
Loosen the clamping levers (A), Move the
bars to the required height and re-tighten
the clamping levers. The adjustment range is
approximately 230mm. When the handle bar
has reached its maximum height, a popper
will engage in the handle bar outer tube (Fig
7, Item B). Press the popper in once the
clamping levers are loose, while adjusting the
height of the handle bar.
Note - It is recommended that the handle
bar is not adjusted beyond the height at
which the popper engages.
Fig 6
A
A
Fig 7
B
8.3 Handle bar angle
The handle bar can be adjusted to an angle
from 90˚ to 120˚ dependant on the desired
back angle of the seating system attached
(fig 8a). In order to adjust the angle of the
handle bar, please refer to Fig 8b.
Pull the lock strap (A), this will release the
locking pins (B) either side of the handle bar.
Adjust the handle bar angle then release the
lock strap. Ensure both locking pins engage
in the locking plate holes (C) after adjustments
are made.
Fig 8a
Fig 8b
A
C
B