Transport; Storage; Care And Maintenance; Frost Protection - Kärcher HD 1050 DE Original Instructions Manual

Turn off the appliance
After operating the water using saline water
(sea water), open the hand spray gun and
rinse the appliance for at least 2 - 3 minutes
using tap water.
 For HD 1050 B:
Set the appliance switch at the engine
to OFF and close the fuel supply valve.
 For HD 1050 DE:
Press the regulator lever at the engine
to "STOP" till the engine comes to a halt
and turn off the fuel tap.
 Shut off water supply.
 Activate trigger gun until device is pres-
sure-less.
 Secure the hand spray gun using the
safety catch so that it doesn't open ac-
cidentally.
 Remove the water inlet hose from the
appliance.

Frost protection

ATTENTION
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
Store the appliance in a heated room dur-
ing winter or empty it. During longer breaks
in operation, it is advisable to pump in anti-
frost agents into the appliance.
Drain water
 Screw off water supply hose and high
pressure hose.
 Operate device for max. 1 minute until
the pump and conduits are empty.
Flush device with anti-freeze agent
Note: Observe handling instructions of the
anti-freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 Use the pushing handle to push the ap-
pliance.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of personal injury or damage! Consider
the weight of the appliance when storing it.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

You can sign with your dealer a contract for
regular safety inspection or even sign a
maintenance contract. Please take advice
on this matter.
Note:The maintenance plan given below
only lists the maintenance tasks for the
high-pressure pump. The maintenance
tasks for the engine must also be done ac-
cording to the details given in the operating
instructions manual of the engine manufac-
turer.
DANGER
Risk of injury if the machine is left running
in an unattended state. Remove the spark
plug connector prior to performing any work
on the device.
Risk of burns! Do not touch hot mufflers,
cylinders or radiator ribs.

Maintenance intervals

Daily
 Check the high pressure hose for dam-
ages (risk of bursting). Please arrange
for the immediate exchange of a dam-
aged high-pressure hose.
Weekly
 Check oil level.
Please contact Customer Service immedi-
ately if the oil is milky (water in oil).
– 6
EN

Transport

Storage

17