Table of Contents
Advertisement
en
Ice cube tray
Fig. 5
Fill the ice cube tray ¾ full of water
and place in the freezer compartment.
If the ice tray is stuck to the freezer
compartment, loosen with a blunt
implement only (spoon-handle).
To loosen the ice cubes, twist the ice tray
slightly or hold briefly under flowing
water.
Ice maker
Fig. 6
1. Remove the ice cube tray, fill ¾ full of
water and re-insert.
2. When the ice cubes are frozen, rotate
the knobs on the ice cube trays
several times to the right and release.
The ice cubes loosen and fall into
the storage container.
3. Remove ice cubes from the storage
container.
Sticker "OK"
(not all models)
The "OK" temperature monitor
can be used to determine temperatures
below +4 °C. Gradually reduce
the temperature if the sticker
does not indicate "OK".
Note
When the appliance is switched on,
it may take 12 hours until
the temperature is reached.
Correct setting
30
Switching off and
disconnecting the
appliance
Switching off the appliance
Fig. 1
Press the On/Off button 1.
Temperature display goes out,
refrigerating unit switches off.
Disconnecting the appliance
If you do not use the appliance
for a prolonged period:
1. Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Clean the appliance.
4. Leave the appliance door open.
Cleaning the appliance
ã=
Caution
Do not use abrasive, chloride or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges.
The metallic surfaces could corrode.
Never clean shelves and containers in
■
the dishwasher.
The parts may warp!
Water used for cleaning must not drip
into the
slots in the front base area in
■
the freezer compartment,
controls,
■
and light.
■
Advertisement
Table of Contents
