Long Cable Compensation Adjustment - NEC MultiSync LCD2180UX User Manual

Long Cable Compensation Adjustment

Long Cable Compensation should only be performed when using extended length cables
or to compensate for a low-quality video signal. To perform the long cable compensation
adjustment, follow these six steps:
1. For optimal adjustment, download the "LCD Long Cable Comp Test Pattern" and "Read
Me" file at www.necmitsubishi.com and display the test pattern during this adjustment.
2. In order to perform the adjustment, enter the Advanced OSM:
• Turn off your monitor.
• Turn on your monitor by pressing the "POWER" and "SELECT" buttons simultaneously
to open the Advanced OSM menu.
3. In Tag 3, set the Auto Adjust Level (Auto SW) to "DETAIL".
"Size" "Fine"
"Position"
SIMPLE O
FULL O
DETAIL O
O: Automatic adjustment is performed.
X: Automatic adjustment is not performed.
*1: Black level, RGB sharpness, RGB delay and RGB position are adjusted using Long Cable Software.
4. In Tag 4, select "AUTO" and press "SELECT" to
perform full adjustment.
5. NEC-Mitsubishi recommends changing (Tag 3)
"AUTO SW"/ "DETAIL" to "SIMPLE" after auto
adjust.
6. Exit the Advanced OSM by turning off and
restarting your monitor.
For additional information on user controls and software utilities, visit our website at
www.necmitsubishi.com
LCD2180UXManual1020.p65
"Contrast"
Long cable capability *1
X
O
O
11
11
Black Level,
X 1.5 seconds
X 2 seconds
O 10 to 20 seconds
10/21/03, 9:10 AM
Time