Sharp MD-MT770 Operation Manual page 104

To add a character:
1. Set the unit to the character input mode.
2. Press the – or + to select the character on the right of the
position where you want to add a character.
3. Select the character you want to add.
4. Press the M button.
5. Press the M button again and hold for 1 second or more.
To erase a character:
1. Set the unit to the character input mode.
2. Press the – or + to select the character you want to erase.
3. Press the REC button.
4. Hold down the M button for 1 second or more.
To change a character:
Erase the character you want to change, and then add a new one.
Stamping titles from another MiniDisc
Before stamping
When there are 2 MiniDiscs on which the same tracks are re-
corded, you can transfer the character information (disc name,
group name, and track name) of the master MiniDisc to another
MiniDisc (for stamping) all at the same time.
1. What is a master MiniDisc?
A recordable MiniDisc that contains tracks and character
information.
2. What is a MiniDisc for stamping?
A MiniDisc that contains the same tracks in the same order as
the master MiniDisc (tracks only).
Stamping character information
1. Insert a master MiniDisc.
Do not mistake the master MiniDisc for the target one.
2. While in the stop mode, press the M button.
The unit enters the menu select mode.
3. Move the M button toward 5 or 4 to select "E (EDIT)" and
press it.
4. Move the M button toward 5 or 4 to select "N (NAME
104
STAMP)" and press it.
5. After "READ OK" is displayed, press the M button.
6. Make sure that "CHANGE MD" is displayed and remove the
master MiniDisc from the unit.
Remove it without turning the power off. Or the operation will be
canceled.
7. Make sure that "INSERT MD" is displayed and insert the MiniDisc
for stamping.
8. Press the M button.
Select the menu within 25 seconds.
If you press the CLEAR button during this operation, the previ-
ous display appears.
To cancel the operation, move the M button toward
Erasing one track at a time (TRACK ERASE)
You can erase one track at a time.
1. During playback of the track to be erased, move the M button
toward 06 to pause it.
You can select the track by moving the M button toward 5 or
4 in the stop mode.
2. Press the M button.
The unit enters the menu select mode.
3. Move the M button toward 5 or 4 to select "E (EDIT)" and
press it.
4. Move the M button toward 5 or 4 to select "E (ERASE)"
and press it.
5. Press the M button again.
Select the menu within 25 seconds.
If you press the CLEAR button during this operation, the previ-
ous display appears.
To cancel the operation, move the M button toward
Erasing all the tracks at once (ALL ERASE)
You can erase all tracks at once.
1. Press the M button while in the stop mode.
The unit enters the menu select mode.
2. Move the M button toward 5 or 4 to select "E (EDIT)" and
press it.
3. Move the M button toward 5 or 4 to select "A (ALL
ERASE)" and press it.
.
.