Download Print this page

Honeywell equip acuix Quick Installation Manual page 4

Ip ptz dome

Advertisement

5
Install the Scan Assembly and Lower Dome
Scan Assembly Installation - All Housing Types
Remove the plastic lens cap. Do not touch the lens.
1
See
Rotate and line up the scan assembly yellow label to the housing
2
G
yellow label. Gently push the scan into the housing until the two guides
lock/snap into the holes on the housing guides.
Gently pull down on the assembly to ensure it has properly latched into
3
place.
Lower Dome Installations
Indoor and Outdoor Pendant
Clip the lanyard from the lower dome to the mounting post in the housing.
1
Although the captive screw is installed correctly on the housing at the factory,
2
it is recommended that you check it is loosened slightly to ensure it is not in
the path of the lower dome gasket during the rest of the installation.
See
Confirm that the trim ring gasket is in place around the inner groove of the
H
3
lower dome and then push the lower dome into the housing until it is sitting
firmly along the bottom edge of the housing. Tighten the captive screws.
Rugged
Clip the lanyard from the lower dome to the mounting post in the housing.
1
Align the 4 lower dome screws with the 4 housing screw holes. Press the lower
2
dome into the housing and turn the security screws using the provided hex key.
In-ceiling
Clip the lanyard from the lower dome to the mounting post in the housing.
1
Insert the trim ring and align the lower dome tab hooks with the 3 mounting posts on the housing.
2
Twist to lock the lower dome into the housing.
H
Indoor and Outdoor Pendant Lower Dome Installations
If the trim ring gasket has shifted from its correct placement, DO NOT stretch the gasket
or the dome may not be sealed properly to protect it from dust and moisture, which may
damage the ACUIX PTZ dome over time.
The trim ring gasket is pre-installed at the factory. It is only correctly
installed in one direction and on one groove.
If you are replacing or adjusting this gasket, ensure you push it all the
way down in the groove with the flat side of the trim ring gasket
installed towards the inside of the groove and upper lip towards the
upper edge of the groove.
4
V2 pendant housings and lower dome models
MUST be installed with each other. For example,
install HDB00P0SW
with HDH00PD00
Scan Assembly
G
Installation
Rotate and align yellow
labels on housing and
scan
.
trim ring gasket
800-01115 Rev B (07-2009)
Housing* locking guide
with holes
Scan assembly
locking guide
(1 of 2)
Lanyard
Lower dome
*Pendant housing shown

Advertisement

loading