Managing Multiple Handsets - Topcom BUTLER E400 User Manual

Managing multiple handsets

8 Managing multiple handsets
8.1 Adding a new handset
Only needed when you have deregistered a handset or when you bought a new one.
You can register new handsets on the base if these handsets support the DECT GAP protocol.
The base can support a maximum of 5 handsets. If you already have 5 handsets, and you wish to
add another one or change one handset, you must first delete a handset, then associate the new
handset.
Putting the base into registration mode:
Register the new handset:
If your additional handset is a Butler E400
4 5 6
GHI JKL MNO
4 5 6
GHI JKL MNO
If your handset is another model
After starting the registration procedure on the base, refer to the handset manual to find out how
to register the handset. The handset must be GAP compatible.
The icon ' ' and the text "NOT REG" flashes on the display when the handset is not associated
with the base.
When a handset is associated with a base, it is attributed a handset number by the base. It is this
number that is displayed on the handset after the name and must be used for internal calls.
DECT GAP Profile only guarantees that basic calling-functions will work correctly
between different brands/types. There's a possibility that certain services (like
CLIP) will not work correctly.
16
1 Press and hold the paging key on the base for 6 seconds. The base will then
emit a beep tone.
The LED on the base will start to blink for 90 seconds. During that time, the
base is ready to register a new handset.
2 Enter the menu
3 Select "REGISTER" and confirm.
4 Select "REG BASE" and confirm.
5 Enter the number of the base to be associated with the handset (1-4) and
confirm. (The flashing numbers are already in use.)
6 Enter the Base PIN code (0000 by default) and confirm.
The handset will start searching for the DECT base. If the handset has located
the base, it will display the base identification number.
7 Confirm or stop.
If the handset does not locate the base, it will return to the standby mode after
a few seconds. Try again by changing the base number and check that you are
not in an environment with interference. Move closer to the base.