Advertisement
MIDI SETUP
The MR5's MIDI channel selection and configuration is
set via the 8 DIP switches on the side panel. It can be
setup to respond to an individual MIDI channel (1-16), or
put into OMNI mode to respond to messages sent on all
MIDI channels simultaneously. Once each switch is set to
its desired position, push the SAVE/RESET button on the
side panel to set the configuration as the changes will not
take affect until you do so. DIP switch details can be found
on the following pages.
OMNI Mode
OMNI Mode allows the MR5 to respond to control and
program changes on any MIDI channel (1-16). Setting
the MR5 to a specific channel is particularly useful when
linking multiple MIDI devices as they can all be set to only
respond to changes on their assigned channel. Some MIDI
equipment will default to OMNI mode when first switched
on, so it is important to check configurations upon power-
up and re-select the channel on your device if necessary.
LED
The side panel is equipped with LED indicators to show you
the status of the MR5. The power LED indicates that the
MR5 is receiving power from your Radial device from the
JR5 connection. The STATUS LED illuminates when a midi
signal is being transmitted to the MR5. The MIDI indicator
shows when a midi device is connected to the MR5.
Radial Engineering Ltd.
1
2
3
4
5
Select OMNI mode by setting DIP
5 in the up position
6
6
7
8
MR5™ User Guide
Advertisement
