Poulan Pro PR500N21SH Operator's Manual page 23

TROUBLESHOOTING - See appropriate section in manual unless directed
to an authorized Service Center.
PROBLEM
Grass catcher
not filling
(If so equipped) 3.
Hard to push
CAUSE
1. Cutting height too low.
2. Lift on blade worn off.
Catcher not venting air.
1. Grass is too high or wheel
height is too low.
2. Rear of lawn mower
housing or cutting blade
dragging in grass.
3. Grass catcher too full.
4. Handle height position not
right for you.
CORRECTION
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting height.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to suit.
23