Panasonic Toughbook CF-17 Series Supplementary Instructions Manual page 3

10 Input your computer name and select [Next].
11 Input an Administrator password and select [Next].
CAUTION
Remember this password! If the password is forgotten, Windows NT cannot be operated.
12 Select [Next].
13 Select [Do not connect this computer to a network at this time], then select [Next].
(Settings can be made for a network even after Windows starts up. In this case, be sure to
read [When Adding New Software or Hardware Components] in the Reference Manual
[Technical Information].)
When establishing settings for a network:
The settings will vary for different network environments depending on the network sys-
tem being used. For more details, ask your system administrator or the person in charge of
the network. Follow the on-screen instructions.
NOTE
It takes several minutes for the necessary files to be copied. If the computer enters the
ECO mode, the power to the LCD is automatically turned off. In this case, press a key
unrelated to the direct triggering of a selection, like
14 Select [Restart Computer]. Select "Windows NT Workstation Version 4.00" and press
15 Following the display, press
Input the password set in step
At the [Welcome], press [Next].
16
After reading the agreement, press [Next].
17
At the [Folder], press [Next].
18
At the [Directory], press [Next].
19
Select [Place icons in system tray], then press [Next].
20
Remove the check mark for [Auto Detect] and select [Custom] in [Ports], then press [Ad-
21
vanced].
Set [Address] to [2E8] and set [Irq] to [7], then press [OK].
22
Press [Next].
23
24 Press [Next].
Press [Finish].
25
At the [Would you like to restart now], select [No]. Close the [Updd] window.
26
Press any key.
27
28
Install the Phoenix APM 2.0 for NT by following the on-screen instructions.
When the installation completes, select [Don't Restart Now].
29
Press any key.
Install the Phoenix Card Executive™ for NT by following the on-screen instructions.
30
When the installation completes, select [Restart Now].
Windows will restart. Select "Windows NT Workstation Version 4.00" and press
The [Begin Logon] display will appear. Perform the operation in step
31
Calibration is executed automatically. Touch the center of each red cross by following
the on-screen instructions. At this time, a timeout will occur if no input is made in a ten-
seconds period. (
period, select [Calibrate] in [Start] - [Programs] - [Updd].
Ctrl
Ctrl + Alt + Del
.
and select [OK], then select [Close] at the [Welcome] display.
11
"Touchscreen"). If the red cross is not touched within the
.
Enter
Enter
15
.
.
.
3