GE JGS968 Owner's Manual page 36

Cleaning the glass cooktop.
Clean your cooktop after
each spill. Use CERAMA
BRYTE ® Ceramic Cooktop
Cleaner.*
Use a CERAMA BRYTE Cleaning
®
Pad for Ceramic Cooktops.*
The CERAMA BRYTE Ceramic
®
Cooktop Scraper* and all
recommended supplies are
available through our Parts Center.
See instructions under "To Order
Parts" section on next page.
NOTE: Do not use a dull or nicked
blade.
36
Control Lockout
Begin by locking the cooktop;
see the Control Lockout section.
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE
Cooktop Cleaner* on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the first
time, clean it with CERAMA BRYTE
Ceramic Cooktop Cleaner.* This helps
protect the top and makes cleanup
easier.
Daily use of CERAMA BRYTE
Cooktop Cleaner* will help keep the
cooktop looking new.
Burned-On Residue
CAUTION:
glass surface may occur if you use
scrub pads other than the pad included
with your cooktop.
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Spread a few drops of CERAMA
BRYTE Ceramic Cooktop Cleaner* on
®
the entire burned residue area.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Use a single-edge razor blade
scraper at approximately a 45°
angle against the glass surface
and scrape the soil. It will be
necessary to apply pressure to the
razor scraper in order to remove
the residue.
*For Canadian models, use a Mabe-approved equivalent when CERAMA BRYTE
Contact Mabe Replacement Parts to order replacement cleaning products.
Ceramic
®
®
Ceramic
®
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
DAMAGE to your
Remove the burner grates and vent
grille.
Shake the cleaning cream well. Apply
a few drops of CERAMA BRYTE
Ceramic Cooktop Cleaner* directly to
the cooktop.
Use a paper towel or CERAMA BRYTE
cleaning pad for Ceramic Cooktops* to
clean the entire cooktop surface.
Use a dry cloth or paper towel to
remove all cleaning residue. No
need to rinse.
Using a CERAMA BRYTE
®
pad for Ceramic Cooktops*, rub the
residue area, applying pressure as
needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMA BRYTE
Ceramic Cooktop Cleaner* and a
paper towel.
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE Ceramic Cooktop
®
Cleaner* on the entire burned residue
area. Use a CERAMA BRYTE
pad for Ceramic Cooktops* to
remove any remaining residue.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE Ceramic Cooktop Cleaner*
®
and a paper towel.
products are not available.
®
®
®
cleaning
®
cleaning
®