Bosch HBL53 Installation Manual page 11

To remove the oven door:
,
Be sure to read the
above WARNING
before attempting to
remove the door.
2. Open the door
completely.
3. Flip levers on hinges
toward you.
,
Holding the door firmly
on both sides and
using both hands,
close the door gently
until it stops against
the levers, about 30 °
from the closed
position.
5. Carefully lift the door
up and out of the
hinge slots. Hold
firmly; the door is
heavy.
6. Place the door in a
convenient and stable
location unitl you are
ready to reinstall it.
Placing the Oven Into the Cabinet
Opening
1. The unit and its bottom packaging (pallet) should be
positioned close to and in front of the cabinet opening
prior to beginning to lift the unit into place.
CAUTION
To avoid damage to the door do not lift, pull or push
the unit during installation by using the oven door
handle as a gripping point.
Note: It is recommended to wear gloves and long sleeves
to protect hands and forearms from abrasion and
potential scratches during the lifting process. It is
also recommended to take off watches and jewelry
and to wear work shoes during installation for foot
protection.
When lifting the unit into place avoid grasping the upper
element to avoid damaging it. See the illustration following
for the correct lifting point.
,
3.
Lift or slide unit into the cabinet cutout without allowing
the unit base to contact the flooring.
Check that the conduit cable does not fall behind the
unit during installation. It may help to run the conduit
into the area it will be connected to (such as an
overhead or adjacent cabinet) and tape the end down
so it doesn't fall out while the unit is being slid into
place.
English 9