Table of Contents
Advertisement
Two levels of access are available:
Read
Read/Write
Enter your IP address and then set your own access rights to Read/Write (see the
following note).
Note: Do not set all the stations in the Access Control table to Read-only. Once this
is set and enabled, it will be difficult to modify the AP. Should this situation
occur, use the AP COMFig utility to reset the configuration.
To set a stations access rights, enter a station's IP address and community string (the
community string is used as a password to access the AP) and choose Read or
Read/Write.
When all the settings are made, click OK to return to the Access Control panel. On
the Access Control panel, click the Apply button to make the changes effective
immediately, without closing the dialog box, or click OK to accept the changes and
close the box.
Perform AP Self Diagnostic Test
On the Service panel, click Perform AP Self Diagnostic Test. The Hardware
Diagnosis window will open (Figure 16).
32 InstantWave
Read-only rights. The user may read everything
except the Access Control settings, but cannot
alter anything
The user may read and alter all settings
11-Mbps Wireless Access Point
Advertisement
Table of Contents
