How To Use This Guide; Etwork - National Datacomm InstantWave NWH660 User Manual

11-mbps wireless access point
Hide thumbs Also See for InstantWave NWH660:
Table of Contents

Advertisement

How to Use this Guide

This user's guide gives complete instructions for installation and use of the
InstantWave NWH660 11-Mbps Wireless Access Point (AP).
Before putting the NWH660 into operation on your LAN, it is important that you
adjust the unit's settings to conform to your networking environment. This can be
done with either of two tools included in the NWH660 package: the AP COM-port
Configuration utility (AP COMFig) or the InstantWave Management System
(IWMS).
AP COMFig lets you carry out basic configuration of the NWH660 off-line, through
the supplied serial cable, using a networked or stand-alone computer. IWMS is a
powerful yet easy-to-use SNMP-based software package for configuration and
management of InstantWave devices over network and internetwork links.
Read through the next section, "Planning the Network," to learn how to get the best
possible performance from your InstantWave wireless network.
Step 1: Plan the wireless network
Step 2: Pre-configure the AP
before installing it on an
existing Ethernet
network
Step 3: Install the AP on the
Ethernet network
Step 4: Carry out on-line
configuration and
management of the AP
via IWMS
14 InstantWave
See "
details.
See "
details.
See "
System
See "
System
11-Mbps Wireless Access Point
Planning the Network
Hardware Pre-configuration
Installing the InstantWave Management
," page 36, for details.
Using the InstantWave Management
," page 39, for details.
," page 15, for
," page 22, for

Advertisement

Table of Contents
loading

Table of Contents