How To Check Remote And Indoor Temperature & Humidity; How To Read The Kinetic Wave Display - Oregon Scientific BAR112HG User Manual

If no signals are received, blanks "---" will be displayed and the
kinetic wave icon will not show.
To force a signal search:
• Press and hold [CHANNEL] & [MEM] for 2-seconds to
enforce a 3-minute search.
This is useful in synchronizing the transmission and reception of
the remote and main units.
Repeat this step whenever you find discrepancies between the
reading shown on the main unit and that on the respective remote
unit.
HOW TO CHECK REMOTE AND INDOOR
TEMPERATURE & HUMIDITY
Display of readings from a remote sensor or the main unit is a one-
step procedure. The remote sensor channel or the main unit display
is indicated in a box under the kinetic-wave icon.
Kinetic-wave
Icon
Designated Indoor
Display Display
To display temperature / humidity readings from the main unit:
• Press [CHANNEL] until a dot is displayed in the box under the
kinetic-wave.
Remote Remote Remote
Display
Display Display
Channel 2
Channel 1 Channel 3
To display temperature / humidity readings from a remote
sensor:
• Press [CHANNEL] until the appropriate remote sensor channel
is displayed in the box under the kinetic-wave.
If no readings are received form one particular channel for more than
15 minutes, blanks "---" will be displayed until further readings
are successfully searched. Check the remote sensor to ensure that it
is secure and that the correct channel has been selected. Optionally,
press and hold [CHANNEL] & [MEM] for 2-seconds to enforce a
search.
HOW TO READ THE KINETIC WAVE
The kinetic wave display shows the signal receiving status of the
main unit. There are three possible forms:
The unit is in searching mode.
Transmission data are securely
registered.
No signal received in search mode.
6
DISPLAY