Advertisement
Calibration
Calibrate petrol/gasoline fuel flow
sensors during installation, or if the fuel
readings seem inaccurate and the other
troubleshooting suggestions do not help.
Note
SmartCraft fuel sensors and NAVMAN
diesel sensors are factory calibrated and
should never need recalibrating.
On a multi engine boat, calibrate each
engine's sensor. This can be done at the
same time with a portable tank for each
engine or at different times using one
portable tank.
Calibrating a sensor requires accurate
measurement of the fuel consumption.
This is best done using a small portable
tank. At least 4 gallons (15 litres) of fuel
should be used to ensure an accurate
calibration.
It is often very difficult to fill underfloor
tanks to the same level twice due to air
pockets, so the more fuel used, the more
accurate the calibration.
To calibrate the sensor(s):
1 Record the level of the fuel in the tank(s).
2 Connect the portable tank(s) to the engine
3 Run the engine at normal cruising speed
4 Check the actual amount of fuel used per
5 Press
6 On a single engine boat, select
NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum
through the fuel sensor(s).
until at least 4 gallons (15 litres) of fuel has
been used per engine.
engine by refilling the portable tank(s) to
the original level and noting the reading(s)
of the fuel dispenser's gauge.
twice, select Fuel, then select
Setup engines.
Calibrate and change the displayed
value to be equal to the reading of the fuel
dispenser's gauge, then press
On a multi-engine boat select the engine.
Select Calibrate and change the
displayed value to be equal to the reading
of the fuel dispenser's gauge, then press
. Repeat for the other engines.
.
5
Advertisement
