Advertisement
Quick Links
Advertisement
Related Manuals for Navman 8084
Summary of Contents for Navman 8084
- Page 1 Navman 8120/8084 Fuel, AIS, & Radar Addendum 06/07 w w w . n a v m a n . c o m...
- Page 2 Enable AIS. Appendix 8084 Size: 190 mm (7.48“) H x 285 mm (11.22“) W x 76.8 mm (3.02“) D. Allow 3 mm clearance on each side for dust cover. 8084 Display: 213.4 mm (8.4”) diagonal, TFT color, 800 x 600 pixels.
- Page 3 What the fuel computer does To ensure the fuel data is accurate: When you add or remove fuel from a tank, tell the 8120/8084. If the boat has petrol/gasoline sensors, calibrate them during installation or if the fuel readings seem inaccurate.
- Page 4 Water speed is better for measuring the boat’s potential performance, Ground speed is better for going to a destination because it takes currents into account. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum...
- Page 5 On a multi-engine boat select the engine. Select Calibrate and change the displayed value to be equal to the reading of the fuel dispenser’s gauge, then press NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum twice, select Fuel, then select . Repeat for the other engines.
- Page 6 • NASA Marine AIS Engine 2 channel MultiPlex Receiver (external GPS). Other AIS receivers may work but have not been tested with this unit. To enable AIS from the system menu check the AIS box. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum...
- Page 7 AIS vessel. For complete AIS information of the AIS vessel place the cursor over an AIS vessel for at least two seconds and press Press either to clear the information. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum...
- Page 8 Show a selectable number of range rings around the boat. The rings are drawn in multiples of the current chart scale. Proximity Alarm When enabled an alarm will activate when any AIS vessel is within the proximity alarm radius. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum...
- Page 9 G Compass ring H Range ring I North line (blue) J Heading line (white) K The bearing (in Relative, True, or Magnetic mode) L Echo Expansion setting M Interference Rejection setting NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum...
- Page 10 An extra menu item will them be displayed to control the radar and overlay. Overlay Palette The color of the radar overlay can be changed, to improve chart/ radar data NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum (transmit (standby mode). Yes. and set...
- Page 11 If you are having problems with these, you may need to relocate the scanner. Consult the Installation Guide for your NAVMAN scanner or talk to your dealer or installer. Multiple echoes off the same object are most likely to occur when you are close to a large target and are usually only a temporary nuisance.
- Page 12 To change the threshold level: 1 From the radar window, press select to decrease or increase the setting. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum Adjust Radar Sea Clutter Level to decrease or increase the Adjust Radar...
-
Page 13: Target Trails
VRM to the edge of the radar window. Use the EBL to find the bearing of the target. 1 From the radar window, press select NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum Echo Expansion . There are Target trails option to... - Page 14 VRM/EBL. This is shown in a different pattern in the radar window. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum VRM/EBL VRM/EBL then 1 (VRM/EBL 1) or 2 to show the VRM and EBL to hide them).
-
Page 15: Guard Zone
• Exit sounds the alarm only when a target leaves the radar guard zone. • Both sounds the alarm when a target enters or leaves the radar guard zone. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum Guard Zone Zone radar guard... - Page 16 North is always at the top of the radar screen. You can easily compare the radar screen to a chart in North up. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum to select the parameter to to change the Guard Zone.
- Page 17 COG data. However, you are strongly recommended to use a good quality product (such as a NAVMAN HS02, HS03 or Autopilot) to provide heading data. There are two choices: • Relative (RM). Your boat remains in a fixed location on the radar screen and all other objects move relative to your position.
- Page 18 The Installation Manual for your NAVMAN radar explains how to find the optimum height for your radar scanner (antenna). Select Antenna height then enter the height of the antenna above sea level. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum Zero bearing then use the...
- Page 19 Sea clutter usually appears as confusing, random signals around your boat. High waves will produce the maximum amount of sea clutter. You can optimize your radar window to reduce the effects of sea clutter. NAVMAN 8120/8084 Fuel, AIS, & Radar Addendum...
- Page 20 Physical Dimensions NAVMAN 8120 NAVMAN 8084...
- Page 21 Lat 36° 48.404’S Made in New Zealand MN000753B-G N av m a n 8120 / 8 0 8 4 Fu e l, AIS, & R a d a r A d d e n d u m...