Installing The Wine Cellar - Dometic SW 180 Installation & Operating Instructions Manual

INSTALLATION INSTRUCTIONS

INSTALLING THE WINE CELLAR

fREE-STANdING INSTALLATION
To install the wine cellar, follow these steps:
1. Place the wine cellar on a strong and
level floor and verify that the door can be
opened wide enough to allow the shelves
to be pulled out.
2. Adjust the feet to allow a 0 mm clear-
ance under the wine cellar.
. Check that the appliance is absolutely
level. It can be levelled by screwing the
adjustable feet at the front of the appliance
up or down.
. Connect to electrical outlet. Secure the
cord behind the unit.
BUILT-IN INSTALLATION
To install the wine cellar, follow these steps:
1. Mount the appliance in the enclosure.
Check for necessary clearance. (Above
clearance should be 50 mm.)
2. Adjust the feet to allow a 0 mm clear-
ance under the wine cellar.
. Check that the appliance is absolutely
level. It can be levelled by screwing the
adjustable feet at the front of the appliance
up or down.
. Connect to electrical outlet. Secure the
cord behind the unit.
MOUNTING THE dOOR HANdLE
To mount the door handle, follow these steps:
1. Remove the door gasket behind the two
holes adapted for the handle. Start in the
upper corner and gently pull out the gas-
ket from the slot. Continue down and pass
the two holes.
2. Insert the two screws in the two pre-
drilled holes.
. Mount the handle. Secure with the two
provided screws.
- 17 -