Preparation For Dehumidification; Preparation For Fan Only - Carrier 51AKP Owner's Manual

STAND-ALONE
The dehumidification only function should be
used if you want to remove moisture from the
room air without lowering the temperature.
STAND-ALONE
Drainage hole
In COOL or DRY mode the condensation water is collected in the water tank.
When the water tank is full, LCD displays error code H8 and the unit stops.
To restart you need to empty the water tank and to stop the unit for 3 minutes.
Plug out the power cord before empty the water tank.
To empty the water tank ,pull out the rubber plug of the pipe, take out the clamp and drain the water in a base pan.
After that, reinsert the plug into pipe to prevent leakage of condensation water and fix the drainage pipe in the clamp.
STAND-ALONE
GB - 4
Preparation for:
dehumidification
Preparation for:
dehumidification
Clamp
Preparation for:
fan only
If the air conditioner is to be used in the fan only mode (ventilation) the
flexible hose should be inserted with the shortest length and bend so
that the air flow coming out from the air conditioner is perpendicular to
the floor.
With the unit in the
dehumidification mode, extract the
flexible hose from the air
conditioner and place it as shown
in the picture.
If you want to use a flexible hose
and direct the hot air flow
according to your needs, place
the hose on a supporting surface.
Rear plate
Rubber plug
Clamp
Drainage
pipe