10°C Heat Operation; Economy Operation - Fujitsu AGYG14LVCB Operating Manual

10°C HEAT OPERATION
• The room temperature can be maintained at 10°C by pressing the 10°C HEAT button
(Fig.5 J) so as to prevent the room temperature from falling too far.
To use 10°C HEAT OPERATION
Press the 10°C HEAT button (Fig.5 J)
The OPERATION Indicator lamp (green) (Fig.3 6) will go out, and the ECONOMY
Indicator lamp (green) (Fig.3 8) will light.
• The direction of airfl ow is set to horizontal.
To stop 10°C HEAT OPERATION
Press the START/STOP button (Fig.5 O)
Then the operation stops.
About the 10°C HEAT OPERATION
• The Heating mode will not operate if the room temperature is high enough.
• The room temperature can be maintained at 10 °C by pressing the 10 °C. HEAT button (Fig.5 J) so as to prevent the room tem-
perature from falling too far.
• In case of multi-type air conditioner, if other indoor unit is used for heating, the temperature of the room where the "10°C HEAT"
function is applied will rise. When using the "10°C HEAT" function, we recommend all indoor units should be run under the"10°C
HEAT" mode.

ECONOMY OPERATION

Begin Air Conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button (Fig.5 K).
The OPERATION Indicator lamp (green) (Fig.3 6) and the ECONOMY Indicator lamp
(green) (Fig.3 8) will light.
Economy operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button (Fig.5 K) again.
The ECONOMY Indicator lamp (green) (Fig.3 8) will go out.
Normal operation begins.
About ECONOMY Operation
In case of single-type air conditioner, at the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner
operation for cooling and heating.
• During ECONOMY operation, the thermostat setting automatically changes according to the temperature to avoid Unnecessary
cooling and heating for the most economical operation.
● If the room is not cooled (or heated) well during economy operation, select normal operation.
● In case of multi-type air conditioner, the economy operation mode is only available for the set indoor unit.
While 10 °C HEAT OPERATION is in
progress, only the following operation
can be used.
• SET
Indicator Lamp
TIMER OPERATION ECONOMY
: Lighting : OFF
Indicator Lamp
TIMER OPERATION ECONOMY
: Lighting : OFF
En-13