Sanyo PLC-WM4500L Service Manual page 21

Mechanical Disassembly
4. ACC Sensor and Sensor C board removal
1. Remove 1 screw-A (T3x6) to take the Sensor C board off.
2. Remove 1 screw-B (T3x8) to take the Lamp Cover Switch (SW901) off.
3. Remove 2 screws-C (M5x10) to take the Terminal Cover off, and remove
1 screw-D (M4x8) and 1 screw-E (M3x8) and then pull the Net Joint Board
Assy upward.
Lamp Cover Switch
(SW901)
5. Lamp, Lamp Cover and ID Connect board removal
1. Loosen 3 screws-A and pull the Lamp Assy upward.
2. Remove 4 screws-B (T3x8) to take the Lamp House Holder upward off.
3. Remove 2 screws-C (T3x8) to take the ID Connect Board.
Lamp Assy
c
c
ID Connect
Board
t3x8
A
B
A
A
A
B
B
B
B
Sensor C board
-21-
e
d
ACC Sensor Board
Assy
Terminal Cover
c
c
Needed to use a special
hex wrench to remove those
screws.