The Timer; Cleaning Lock Function; Automatic Time Limitation - Siemens EH675MV17E Instruction Manual

Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming panel, the cooking time is reduced by one
minute, if it is held down the time is automatically reduced to
one minute.
If the previous setting from 6 to 10 is pressed in the
programming panel , the cooking time is increased by one
minute, if it is held down the time is automatically increased to
99 minutes.
Changing or cancelling the time
Press the symbol several times until the required
0
indicator lights up. Change the cooking time in the
programming panel, or set to
Once the time has elapsed
The hotplate switches off. An audible signal sounds and
appears in the time program function display for 10 seconds.
The indicator lights up. Pressing the
x
indicators and stops the signal.
Notes
If a cooking time has been programmed in several zones, it
■
can be set to display all time values. To do this, press the
symbol several times until the
hotplate lights up.
Cooking times of up to 99 minutes can be programmed.
■

Cleaning lock function

Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the symbol. A signal sounds. The control panel is
#

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
12
x
‹‹ .
‹‹
symbol turns off the
0
x indicator for the required
and
"

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
Programming
Press the symbol several times until the
0
1.
up. lights up in the time program function display.
‹‹
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the symbol several times until the
0
up. Change the cooking time in the programming panel, or set
to .
‹‹
Once the time has elapsed
A warning beep sounds. In the time program function display
is shown, and the
‹‹
the indicators turn off.
Pressing the symbol turns off the indicators and stops the
0
beep.
0
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.
Note: The lock does not affect the main switch. The hob may
be switched off when desired.
‰
indicator lights
W
indicator lights
W
indicator comes on. After 10 seconds
W