Table of Contents
Advertisement
Time-setting options
en
OTime-setting options
Your hob has two timer functions:
i o n s
T i m e - s e t t i n g o p t
Programming the cooking time
■
Kitchen timer
■
Programming the cooking time
The hotplate automatically switches off after the time
that is set has elapsed.
Setting procedure:
Select the hotplate and the required heat setting.
1.
Touch the
symbol.
0
2.
the hotplate.
lights up on the timer display.
‹‹
Within the next 10 seconds, set the required cooking
3.
time in the settings range.
After a few seconds, the time begins to elapse.
Notes
The same cooking time can be set automatically for
■
all hotplates. The set time for each of the hotplates
counts down independently.
You can find information on automatically
programming the cooking time in section ~ "Basic
settings"
If the flexible cooking zone is selected as the only
■
hotplate, the set time for the entire cooking zone is
the same.
Frying sensor
If a cooking time has been programmed for a hotplate
and the frying sensor has been activated, the cooking
time will not begin to count down until the selected
temperature setting has been reached.
Changing or cancelling the time
Select the hotplate and then press the
Change the cooking time using the programming zone
or set to
‹‹
in order to cancel the time.
14
lights up on the display for
x
symbol.
0
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The
time program function lights up
the display.
When the
symbol is pressed, the indications turn off
0
and the beeping stops.
Notes
If a cooking time was programmed for several
■
hotplates, the time information for the selected
hotplate is shown in the timer display.
You can set a cooking time of up to 99 minutes.
■
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Programming
Press the
symbol several times until the
0
1.
indicator lights up.
‹‹
function display.
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the
symbol several times until the
0
lights up. Change the time with the programming zone,
or set to
.
‹‹
Once the time has elapsed
A warning signal sounds. In the time program function
display
is shown, and the
‹‹
After 10 seconds the indicators turn off.
When the
symbol is pressed, the indicators turn off
0
and the beeping stops.
‹‹
for 10 seconds in
W
lights up in the time program
indicator
W
indicator lights up.
W
Advertisement
Table of Contents
