Dvd Deck Section - Pioneer DV-600AV-S Service Manual

1

7.2 DVD DECK SECTION

2. REMOVAL OF DVD DECK PARTS
NOTE
A
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the disassembly
is done. If the repair is needed except listed parts,
replace the DVD MECHA ASS'Y.
2-1: TRAY (Refer to Fig. 2-1-A)
1. Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
2. Unlock the 2 supports 1 and draw it while sagging the
Tray.
B
Push to Sag
1
Tray
NOTE
C
1. In case of the Tray installation, install them as the circled
section of Fig. 2-1-B so that the each markers are met.
Loader Ass'y
D
2-2: TRAVERSE ASS'Y (Refer to Fig. 2-2-A)
1. Remove the screw 1.
2. Unlock the 2 supports 2.
3. Remove the Insulator (R) from the Loader Sub Ass'y.
4. Remove the Traverse Ass'y.
E
Loader Sub Ass'y
Traverse Ass'y
• Screw Torque: 2.0 ± 0.3kgf•cm
F
36
1
2
Loader Ass'y
Push to Sag
Fig. 2-1-A
Tray
Fig. 2-1-B
1
2
2
Insulator (R)
Fig. 2-2-A
2
3
NOTE
1. In case of the Traverse Ass'y, install it from (1) to (4) in
order. (Refer to Fig. 2-2-B)
2. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-2-C.
Loader Ass'y (Bottom Side)
2-3: LOADING MOTOR PCB ASS'Y/ LOADING BELT
(Refer to Fig. 2-3-A)
1. Remove the Loading Belt.
2. Remove the screw 1.
3. Remove the Loading Motor PCB Ass'y.
4. Remove the 2 screws 2.
5. Remove the Loading Motor.
6. Remove the Gear Pulley.
Loading Belt
• Screw Torque: 2.5 ± 0.3kgf•cm (Screw 1)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 2)
DV-600AV-S
3
4
Rack Loading
Holder Traverse
Traverse Ass'y
Check Lock
Loader Ass'y
Check Hook
2
2
Loading Sub Ass'y
Gear Pulley
Loading Motor
Loading Motor PCB Ass'y
1
4
Fig. 2-2-B
Fig. 2-2-C
Fig. 2-3-A