National Instruments NI 9217 Operating Instructions Manual page 6

Special Conditions for Hazardous Locations Use in Europe
This equipment has been evaluated as EEx nC IIC T4 equipment
under DEMKO Certificate No. 03 ATEX 0324020X. Each module
is marked
locations. If you are using the NI 9217 in Gas Group IIC hazardous
locations or in ambient temperatures of –40 °C ≤ Ta ≤ 70 °C, you
must use the device in an NI chassis that has been evaluated as
EEx nC IIC T4, Ex nA IIC T4, or Ex nL IIC T4 equipment.
Special Conditions for Marine Applications
Some modules are Lloyd's Register (LR) Type Approved for
marine applications. To verify Lloyd's Register certification, visit
ni.com/certification
look for the Lloyd's Register mark on the module.
Caution
for marine applications, use shielded cables and install
the system in a metal enclosure. Suppression ferrites
must be installed on power supply inputs near power
entries to modules and controllers. Power supply and
module cables must be separated on opposite sides of the
enclosure and must enter and exit through opposing
enclosure walls.
NI 9217 Operating Instructions and Specifications
II 3G and is suitable for use in Zone 2 hazardous
and search for the LR certificate, or
To meet radio frequency emission requirements
6 ni.com