Table of Contents
Advertisement
FREQUENCY SHIFT DIRECTION (SFT-D) ---- MENU24
In standby mode, press MENU + 24. The screen will display "SFT-D".
Press MENU to enter the function. Press the ▲/▼ buttons to select +/-/OFF, then press MENU
to confirm.
To return to the standby mode press EXIT.
+ (positive offset): If the transmitting frequency is higher than the receive one.
- (negative offset): If the transmitting frequency is lower than the receive one.
OFF: frequency shift turned off.
STOPWATCH TIMER (SECOND) --- MENU 25
In standby mode, press MENU + 25. The screen displays "SECOND".
Press MENU to enter. Press the ▲/▼ buttons to enable/disable (ON/OFF) the function, then press
MENU to confirm. To return to the standby mode press EXIT.
Using the stopwatch timer:
When this function is ON, press
Press
again to re-start counting.
To exit the function, stop the counting first, and then press the EXIT button.
CHANNEL NAME (CHNAME) --- MENU 26
To set the channel name, you have at your disposal 26 letters (A to Z) and 10 numbers (0 to 9).
You can choose only 6 characters to create the channel name.
To edit the channel name:
At least one channel should have been stored.
To display the name of the channels, press MENU + 21.
Select the desired channel, then press MENU+ 26 + MENU. The screen displays six '_' symbols.
Press ▲ to select the character and ▼ to confirm and go on, then press ▲ again to select the se-
cond character. and ▼ to confirm and go on. After have selected the sixth characters press MENU
to confirm. To exit the function press EXIT. The screen displays the channel name and also the
channel number on the right corner of the display.
STORED CHANNELS (MEM-CH) --- MENU 27
In Frequency and in Standby mode, you can store frequencies and parameters.
Press MENU + 27; the screen will display "MEM-CH".
Press MENU to enter the function. Press the ▲/▼ buttons to select the channel, then press MENU
to store it.
A vocal sound will confirm the storing success. Press EXIT to exit the current channel
E.g.: to set 430.025MHz as receiving frequency and 435.025MHz as transmitting frequency in
CH-20, follow these steps:
1. On Frequency mode, digit 430025, then MENU+ 27 + MENU, to enter the function. Digit 20 or
use the ▲/▼ buttons to select CH-20. Press MENU to confirm. A vocal sound will confirm the
storage success, then press the EXIT button.
2. Digit 435025 and then MENU+ 27 + MENU + MENU. A vocal sound will confirm the storage
success, then press the EXIT button.
NOTE:
If the stored channel needs a CTCSS/DCS code, you should set it before storing the channel.
It is possible to transmit on the stored channel only if you have stored its frequency first.
Manual storage is possible only on empty channels, after have deleted all the previous parame-
ters.
to start counting, to stop counting you can press any key.
11
Advertisement
Table of Contents
